Configuring Nd Mad - HP 5900 Series Configuration Manual

Step
6. Assign the port to the ARP
MAD VLAN.
7. Return to system view.
8. Enter VLAN interface view.
9. Assign the interface an IP
address.
10. Enable ARP MAD.

Configuring ND MAD

When you use ND MAD, follow these guidelines:
• Enable the IRF fabric to change its bridge MAC address as soon as the master leaves.
If the intermediate device is in an IRF fabric, assign this fabric a different domain ID than the ND
•
MAD-enabled fabric to avoid false detection of IRF split.
If an intermediate device is used, you can use common data links as ND MAD links. If no
•
intermediate device is used, set up dedicated ND MAD links between IRF member devices.
Use a VLAN dedicated to ND MAD.
•
On the intermediate device, create the ND MAD VLAN and assign the ports on the ND MAD links
•
to the VLAN.
To configure ND MAD:
Step
1. Enter system view.
2. Assign a domain ID to the IRF
fabric.
3. Create a VLAN dedicated to
ND MAD.
4. Return to system view.
5. Enter Ethernet interface view.
Command
•
Assign the port to the VLAN as an
access port:
port access vlan vlan-id
•
Assign the port to the VLAN as a
trunk port:
port trunk permit vlan vlan-id
•
Assign the port to the VLAN as a
hybrid port:
port hybrid vlan vlan-id { tagged |
untagged }
quit
interface vlan-interface
vlan-interface-id
ip address ip-address { mask |
mask-length }
mad arp enable
Command
system-view
irf domain domain-id
vlan vlan-id
quit
interface interface-type
interface-number
28
Remarks
Choose one command
depending on the port type.
ARP MAD detection has no
requirement for the link type of
the detection port.
The default link type of a port is
access.
N/A
N/A
By default, no IP address is
assigned to any VLAN interface.
By default, ARP MAD is
disabled.
Remarks
N/A
The default IRF domain ID is 0.
The default VLAN on the device
is VLAN 1.
N/A
N/A