Displaying And Maintaining An Irf Fabric; Configuration Examples; Lacp Mad-Enabled Irf Configuration Example - HP 5900 Series Configuration Manual

Step
1. Enter system view.
2. Change the state of the IRF fabric from
Recovery to Active.
After the IRF fabric is recovered, all ports that have been shut down by MAD automatically come up.

Displaying and maintaining an IRF fabric

Execute display commands in any view.
Task
Display information about all IRF
members.
Display the IRF fabric topology.
Display IRF link information.
Display IRF configuration.
Display the load sharing mode for
IRF links.
Display MAD configuration.

Configuration examples

This section provides IRF configuration examples for IRF fabrics that use different MAD mechanisms.

LACP MAD-enabled IRF configuration example

Network requirements
Set up a four-chassis IRF fabric at the access layer of the enterprise network in
MAD in the IRF fabric, because the IRF fabric has a multichassis aggregate link to Device E, an HP device
that supports extended LACP.
Command
system-view
mad restore
Command
display irf
display irf topology
display irf link
display irf configuration
display irf-port load-sharing mode [ irf-port [ member-id/port-number ] ]
display mad [ verbose ]
31
Figure 14. Configure LACP