To Pedal] Jack - Yamaha Arius YDP-103 Owner's Manual

2-5
Securely tighten the screws on the top of B
that were attached in Step 2-2.
E
2 - 3
2 - 1
Place the
bottom ends
of the rear
panel on
each foot.
3.
Secure C.
Securely tighten the screws on C that were
attached in Step 1-3.
D
3
4.
Mount A.
Be sure to place your hands at least 10 cm from
either end of A when positioning it.
A
At least
10 cm
E
At least
10 cm
B
2 - 2, 2 - 5
B
D
2 - 4
2 - 3
B
E
C
D
CAUTION
• Fingers can become pinched between the main unit and the
rear or side panels, be extra careful so as not to drop the
main unit.
• Do not hold the keyboard in any position other than the
position shown in the illustration.
5.
Secure A.
5-1
Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2
Secure A by tightening the short screws
(6 x 16 mm) from the front.
5 - 1
Projection of A
6.
Connect the pedal cord and the AC
adaptor.
6-1
Insert the pedal cord plug to the
[TO PEDAL] jack from the rear.
6-2
Securely wind the cord holder around the
pedal cord.
The cord holder is attached to D.
6-3
Insert the AC adaptor plug into the DC IN
jack from the rear.
Keyboard Stand Assembly
2
5 - 2
23
YDP-103 Owner's Manual