Data Backup And Initializing; Appendix; Troubleshooting - Yamaha Arius YDP-103 Owner's Manual

Data Backup and Initializing

The following data will automatically be maintained as backup data even if you turn off the power.
Backup data
Metronome Volume, Metronome Beat, Touch Sensitivity, Tuning, Auto Power Off, Operation Confirmation
Sound on/off
To initialize the backup data:
While holding down the C7 key (right-most key), turn the power on to initialize the backup data to the factory ini-
tial settings.
NOTICE
Never turn off the power while the initialization is being executed.
NOTE
If this instrument somehow malfunctions or fails to operate properly, try executing the initialization.

Appendix

Troubleshooting

Problem
Power suddenly and
unexpectedly turns off.
The instrument does not
turn on.
A click or pop is heard when
the power is turned on or off.
Noise is heard from the
speakers or headphones.
Noise is heard from the
instrument's speakers or
headphones when using the
instrument with the application
on iPhone/iPad.
The overall volume is low, or no
sound is heard.
Pedals do not function.
The damper pedal does not
function as expected.
C7
This is normal and the Auto Power Off function may have been activated (page 13).
If desired, disable the Auto Power Off function.
The plugs are not properly connected. Make sure that the DC plug is securely inserted into
the DC IN jack on the instrument, and that the AC plug is securely inserted to the AC outlet
(page 12).
This is normal when electrical current is being applied to the instrument.
The noise may be due to interference caused by the use of a mobile phone in close
proximity to this instrument. Turn off the mobile phone, or move it further away from this
instrument.
When you use the instrument along with the application on your iPhone/iPad, we recommend
that you set "Airplane Mode" to "ON" on your iPhone/iPad in order to avoid noise caused by
communication. While Bluetooth is connected, setting "Airplane Mode" to "ON" disconnects
Bluetooth; however, the connection can be restored by reconnecting again.
The Master Volume is set too low. Set it to an appropriate level using the [MASTER VOLUME]
knob (page 12).
Make sure a pair of headphones or conversion adaptor is not connected to the [PHONES]
jack (page 13).
The pedal cord may not be securely connected to the [TO PEDAL] jack. Be sure to insert the
pedal cord all the way until the metal part of the cord plug disappears from view (page 23).
The damper pedal was pressed when the power was turned on. This is not a malfunction;
release the pedal and press it again to reset the function.
Possible Cause and Solution
21
YDP-103 Owner's Manual