Yamaha Arius YDP-103 Owner's Manual page 24

Keyboard Stand Assembly
Insert the pedal cord securely until the metal part of the
cord plug disappears from view. Otherwise, the pedal may
not function properly.
7.
Set the adjuster.
Rotate the adjuster until it comes in firm contact
with the floor surface.
24
YDP-103 Owner's Manual
6 - 1
6 - 3
B
After completing the assembly, please check the
6 - 2
following.
• Are there any parts left over?
 Review the assembly procedure and correct any errors.
• Is this instrument clear of doors and other
movable fixtures?
 Move the instrument to an appropriate location.
• Does this instrument make a rattling noise when
you shake it?
 Tighten all screws.
• Does the pedal box rattle or give way when you
step on the pedals?
 Turn the adjuster so that it is set firmly against the
floor.
• Are the pedal cord plug and the adaptor plug
inserted securely into the sockets?
D  Check the connection.
When moving the instrument
CAUTION
When moving the instrument after assembly, always hold
the bottom of the main unit. Do not hold the key cover or
top portion. Improper handling can result in damage to
the instrument or personal injury.
NOTICE
Rotate the adjuster under the pedal until it separates from
the floor surface. Contact with the adjuster can result in
damage to the floor surface.
Key cover
Hold here.
Separate the adjuster
from the floor surface.
Transporting
If you move to another location, you can transport the
instrument along with other belongings. You can move the
unit as it is (assembled), or you can disassemble the unit
down to the condition it was in when you first took it out of
the box. Transport the keyboard horizontally. Do not lean it
up against a wall or stand it up on its side. Do not subject
the instrument to excessive vibration or shock. When
transporting the assembled instrument, make sure all
screws are properly tightened and have not been loosened
by moving the instrument.
CAUTION
If the main unit creaks or is otherwise unsteady when you
play on the keyboard, refer to the assembly diagrams and
retighten all screws.
Do not hold here.
Top portion