ENGLISH
BRUSHING SYSTEM
BRUSH/PAD-HOLDER DECK OR CYLINDRICAL BRUSH DECK DISASSEMBLY/ASSEMBLY
The.machine.can.be.equipped.with.either.the.brush/pad-holder.deck.(18a).or.the.cylindrical.brush.deck.(18b),.according.to.the.following.
procedures.
WARNING!
When the deck is installed/removed, it may be necessary to change the squeegee too, because they must have
the same width. For correct matching of deck and squeegee, see the Squeegee Installation paragraph in the User
Manual.
Disassembly
1.
Drive the machine on a level floor.
2.
Remove.the.brushes/pad-holders,.as.shown.in.the.User.Manual..Do.not.remove.the.cylindrical.brushes.
3.
Lower.the.brush/pad-holder.deck.by.pressing.the.pedal.(11)..
4.
Remove.the.cotter.pins.(B),.then.remove.the.gas.spring.(A),.if.equipped.
5.
Disconnect.the.brush/pad-holder.motor.electrical.connection.(D).
6.
Disconnect.the.solution.hose.connection.(E).
7.
Remove.the.screws.(C),.then.remove.the.brush/pad-holder.deck.(F).
Assembly
1.
Assemble.the.components.in.the.reverse.order.of.disassembly,.and.note.the.following:
•
When.the.machine.is.equipped.with.the.cylindrical.brush.deck.(18c),.the.gas.spring.(A).must.not.be.installed.
B
A
B
18
D
C
SERVICE MANUAL -
FOCUS
E
F
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
S301531A
L20
®