Table of Contents
Advertisement
Page 15 of 24
IP Filter Settings
IP filtering is used to block un-wanted users either from local or remote side.
Out-bound IP
Filtering:
In-Bound IP
Filtering:
Rule:
Protocol:
Port Range:
Enable this function will block all registered IP address on Local network.
Enable this function will block all unregistered IP address to send in packet.
Only registered IP address can send in packet under rule's restriction.
If Rule is click, the IP address can send it packet.
It can define to allow TCP, UDP or both to communicate.
It specifies port number or range to accept.
For Support Contact +61-2-9956-7377
Or support@etmpacific.com.au
ETM350C ETM450C User ManualV008.docx
Advertisement
Table of Contents
