Lan Settings - ETM ETM450C User Manual

Page 13 of 24
Keep Alive:

LAN Settings

Gateway IP:
IP Address:
Subnet Mask:
DHCP Client Range: This is the range that Router will assign IP address to devices which
st
1 DNS:
nd
2 DNS:
Assign IP by MAC:
When you have finished these settings, you must click on the [Apply change] button.
This is to make sure that router is on-line all the time. If enable is chosen,
the router will ping the nominated IP address with interval time and IP set
st nd
by user on 1 or 2 or both server. The 'ping fail' count is incremented only
if all configured servers fail to respond. If the count reaches the preset
value then the router will be reset and re-connect again.
Select either Static or DHCP Client. If Static is chosen, the Router will use
the static IP address shown on "IP address". If DHCP Client is chosen, the
Router IP address will be assigned by connecting host. Default is Static.
To assign IP address for Router. Default is 192.168.0.1
Default is 255.255.255.0
connect to this router. Default is 192.168.0.200-192.168.0.250
DNS address. Default is 168.126.63.1
DNS address. Default is 168.126.63.2
Allows specific MAC addresses to be assigned to specific IP addresses
For Support Contact +61-2-9956-7377
Or support@etmpacific.com.au
ETM350C ETM450C User ManualV008.docx