Table of Contents
Advertisement
Speaker installation options
∫ Attaching to a wall
You can attach all of the speakers (except subwoofer) to a wall.
≥ The wall or pillar on which the speakers are to be attached
should be capable of supporting over 15 kg
screw. Consult a qualified building contractor when attaching the
speakers to a wall. Improper attachment may result in damage to
the wall and speakers.
≥ When mounting the front speakers or surround speakers to a
wall, we recommend using a string (not included) to prevent it
from falling.
[HT995W]
4 Screws
Preparation for front and surround speakers
[HT995]
1
Pull down the longer
part of the cable to
release the cable from
the groove inside the
stand, and then pull the speaker cable out from the stand.
2
Feed the cable into the bottom of the
speaker and through the slot at the rear.
3
Connect the cable (➜ page 6).
[HT995W]
1
Remove the speaker cable from the stand.
2
Connect the cable (➜ page 7).
[HT995W]
1
Attach the cover plate to the front speaker or surround
speaker.
Cover plate
2 Drive a screw (not included) into the wall.
‰4.0 mm
Wall or pillar
3 Fit the speaker securely onto the screw(s) with the hole(s).
Front and surround speaker [HT995]
255 mm
320 mm
8
([HT995W]
10 kg) per
[HT995W]
4 Cover plates
Release the cable
from the groove.
Screw
Tighten securely.
‰7.5 to 9.5 mm
5.0 to 7.0 mm
Center speaker [HT995]
190 mm
[HT995W]
Front and surround speaker
106 mm
340 mm
e.g.
In this position, the
speaker will likely
fall if moved to the
left or right.
Reattaching the speaker cable to the stand
[HT995]
1 Remove the two screws from the stand, and remove the metal cover.
Screw
Metal cover
Plastic cover
2 Pull the cable out about 40 cm from the hole in the metal cover, and
insert the plastic cover.
Approx. 40 cm
3 Insert the metal cover
so it does not disturb
the cable and close
tightly with the two screws.
[HT995W]
1 Remove the eight screws
from the stand, and remove
the speaker net.
2 Position the cable.
Press the cable into
the groove.
Approx.
15 cm
3 Attach the speaker net with the screws.
∫ Fitting speaker stands
(For center speaker)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance
between screws as shown in the diagram.
≥ The stands must be able to support over 10 kg.
≥ The stands must be stable even if the speakers are in a high position.
e.g. Center speaker [HT995]
Metal screw holes
For attaching to
speaker stands
5 mm, pitch 0.8 mm
Plate thickness plus
7 mm to 10 mm
[HT995W]
Center speaker
200 mm
Move the speaker
so that the screw is
in this position.
Screw
Screw
Cable
(not included)
60 mm
Speaker stand
(not included)
Hide quick links:
Advertisement
Table of Contents
