KIP 3100 User Manual page 42

3. When the feeding rollers catch the paper, turn the middle of the Guide Plate (4) towards
the outside.
Rotate the Paper Feeding Knob (2) again until 8.5" (210mm) of the leading edge comes out.
4. Slide the green Cutter Knob (5) fully from one side to the other to make a new straight edge.
Remove the cut portion.
NOTE
Completely slide the Cutter Knob until it stops at either end.
Not doing so may cause a paper jam.
9. Close Roll Deck.
NOTE
Be sure to close the Roll Deck fully until it locks at the correct position.
A paper jam may occur if it is not locked firmly.
4
3-4
Leading edge
2
Chapter 3 Error Correction
5