Yamaha CVP-709 Owner's Manual page 103

2
Attach two front legs and a rear leg.
Refer to the diagram below to verify the orientation of the
legs.
Front leg
Install and tighten four screws on each leg, starting with
one of the front legs.
6 x 40 mm fixing screws
3
Install the pedal box.
1 Remove the twist tie and tape that affix the pedal cord to
the upper portion of the pedal box.
Tape
2 Align the cord with the groove on the unit, and attach the
pedal box using four screws.
6 x 20 mm fixing screws
Rear leg
Front leg
Twist tie
3 Insert the pedal cord plug into the pedal connector.
Insert the plug into the connector so that the side with the
arrow mark is facing forward (keyboard side). If the plug
does not fit easily do not try to force it, but check the plug
for correct orientation, and then reinsert it into the
connector.
Insert the pedal cord securely until the metal part of the
cord plug disappears from view. Otherwise, the pedal may
not function properly.
4 Attach the cord holder on the unit as shown in the
illustration below, then use the cord holder to affix the
pedal cord.
3
4
Raise the unit to the standing position.
Use the front legs as support to raise the unit.
CAUTION
• Be careful not to pinch your fingers.
• When you raise the unit, do not hold the key cover.
.
CVP-709/CVP-705 Owner's Manual
4
103