Stihl TS 500i Instruction Manual page 22

English
Removing the "cast arm with guard"
3
1
2
1
1
Remove the nuts (1)
N
Remove the "starter cover with
N
rewind starter" (2)
Remove the "cast arm with
N
guard" (3) from the studs
Preparing the "cast arm with guard" for
outboard mounting
1
Unscrew the stop pin (1)
N
20
1
4 5
Turn the guard so that it is in the
N
position shown (see picture)
Screw in and tighten the stop pin (1)
N
Move the adjusting lever (2) to
N
position A
Screw in the bolt (3) and tighten up
N
Remove screw (4) from the limit
N
stop (5)
Pull off the limit stop (5)
N
6
4 5
Turn the "cast arm with guard" so
N
that the guard is on the outboard
side
Insert limit stop (5) – align the hole
N
in the limit stop with the hole in the
cast arm
Screw in the bolt (4) and tighten up
N
Insert the square nut into the guide
N
in the guard and hold it in place
Screw in the shorter banjo bolt (6)
N
and washer at the adjusting lever
A
and tighten up with the combination
wrench
Mounting "cast arm with guard" – guard
3 2
on the outboard side
1
2
4
Press the oblong holes (1) in the
N
"cast arm and guard" on to the
studs (2), guiding the ribbed V-belt
over the front pulley
NOTICE
The belt action must run smoothly.
The belt tensioner (3) must sit close
N
to the lug (4)
1
2
1
2
3
TS 480i, TS 500i