__________________________________________________________________________________________________________________________________________________________
Assembly of the small input PCB P4040i:
This PCB is used to connect the input signal (via two RCA sockets) via two holes at the rear of the cabi-
net.
1. CAPACITORS
q
C1: 47nF (473, 0.047)
2. CINCH / RCA CONNECTOR
Mount them as straight and square as possible
against the PCB
q
SK1: CINCH
q
SK2: CINCH
3. SHIELDED WIRE CONNECTION
Carefully strip the screened cable supplied and
make the connection as shown in the figure
C...
q
q
q
q
15cm
P4040i
L
R
GND
GND
LEFT
GND
GND
RIGHT
5