Horizon Fitness endurance 3 Owner's Manual page 5

ASSEMBLY STEP 3
CONSOLE MAST
PRE-INSTALLED BOLTS
PRE-INSTALLED WASHERS
GUIDE RAIL SET
FLAT WASHER(I)
SPRING WASHER(H)
PEDAL ARM
PEDAL ARM WHEEL
NOTE: Be careful not to pinch any wires
while attaching the console
8
HARDWARE foR STEP 3:
BOLT (G) SPRING WASHER (H)
20 mm 15 mm
Qty: 2 Qty: 2
WAVY WASHER (J)
22 mm
Qty: 2
Open HARDWARE FOR STEP 3.
A
Carefully pull the CONSOLE CABLE through
B
the CONSOLE MAST using the twist tie located
CONSOLE CABLES
inside the CONSOLE MAST.
MAIN FRAME
Attach the CONSOLE MAST to the MAIN
C
CRANK FRAME using 4 PRE-INSTALLED BOLTS and 4
PRE-INSTALLED WASHERS.
WAVY WASHER(J)
Slide 1 WAVY WASHER (J) over CRANK
d
followed by PEDAL ARM as shown. Rest PEDAL
ARM WHEEL on GUIDE RAIL SET.
Attach PEDAL ARM to CRANK using 1 BOLT
E
(G), 1 SPRING WASHER (H) and 1 FLAT
WASHER (I).
BOLT(G)
F Repeat steps d-E on the opposite side.
mast.
ASSEMBLY STEP 4
FLAT WASHER (I)
20 mm
Qty: 2
CONSOLE MAST
RUBBER WASHER(O)
BOLT (K)
20 mm
Qty: 2
FLAT WASHER (N)
25 mm
Qty: 4
Open HARDWARE FOR STEP 4.
A
Slide 1 RUBBER WASHER (O) and 1 FLAT
B
FLAT WASHER(N)
WASHER (N) onto CONSOLE MAST.
FLAT WASHER(M)
Slide LOWER HANDLEBAR onto CONSOLE
C
MAST and attach using 1 FLAT WASHER (N),
1 FLAT WASHER (M), 1 HANDLEBAR CAP, 1
FLAT WASHER (M), 1 SPRING WASHER (L)
and 1 BOLT (K).
Repeat steps B-C on the opposite side.
d
HANDLEBAR CAP
SPRING WASHER(L)
BOLT(K)
LOWER HANDLEBAR
HARDWARE foR STEP 4:
SPRING WASHER (L) FLAT WASHER (M)
15 mm 20 mm
Qty: 2 Qty: 4
RUBBER WASHER (O)
26 mm
Qty: 2
9