Taking The Unit Into Operation With Coating Material; Spraying Technique - WAGNER HC 55 E-SSP Operating Manual

Starting operation
Switch unit off O (OFF). Unplug power plug and turn
the polarity changer (5) in the power plug by 180°
with a screwdriver. Plug in power plug again.
5. Ball valve (6) on the material feed pump – set lever to
a vertical position – switch on hydraulic motor.
Hydraulic oil flows to the hydraulic motor of the mate-
rial feed pump.
6. Turn the pressure regulating knob (2) to the right
(pressure increase) until cleaning agent exits the
return hose.
7. Turn relief valve knob (3) to the right (p spray).
8. Pull the trigger guard of the spray gun.
9. Spray the cleaning agent from the unit into an open
collecting container.
6 3
HC55E
HC55E-SSP
HC 35 E • HC 45 E • HC 55 E
1 2 4
5
g
4.6 Taking the unit into operation with
coating material
1. Pull retention pin (fig. 13, item 1) and swivel material
feed pump into the coating material container.
2. Turn the pressure regulating knob (2) on the hydraulic
pump to the left (pressure reduction) until it stops.
3. Turn the relief valve knob (3) three revolutions to the
left (k Circulation).
4. Switch on the unit.
HC 35 E • HC 45 E • HC 45 E-SSP
Set switch to 1 (ON).
HC 55 E • HC 55 E-SSP
First set switch button to Y, then to
The direction of rotation of the pulley must corre-
spond to the arrow (4) on the belt cover. If the belt is
running opposite the direction of the arrow:
Switch unit off O (OFF). Unplug power plug and turn
the polarity changer (5) in the power plug by 180°
with a screwdriver. Plug in power plug again.
5. Ball valve (6) on the material feed pump – set lever to
a vertical position – switch on hydraulic motor.
Hydraulic oil flows to the hydraulic motor of the mate-
rial feed pump.
6. Turn the pressure regulating knob (2) to the right
(pressure increase) until coating material exits the re-
turn hose.
7. Turn relief valve knob (3) to the right (p spray).
8. Pull the trigger guard of the spray gun, then set the
desired operating pressure by means of the pressure
regulating knob (2).
9. The unit is ready to spray.

5. Spraying technique

Move the spray gun evenly during the spraying process.
Otherwise the spray pattern will be uneven. Carry out the
spray movement with the arm, not with the wrist. Obser-
ve a parallel distance of approx. 30 cm between the
spray gun and the object of spraying. The lateral edge of
the spray jet should not be too distinct. The spray edge
should be gradual in order to facilitate overlapping of the
next coat. Always move the spray gun parallel and at an
angle of 90° to the surface to be coated in order to mini-
mize the paint mist.
If very sharp edges result or if there are stre-
i
aks in the spray jet – increase the operating
pressure or dilute the coating material.
Spraying technique
(ON).
43