Table of Contents
Advertisement
IEEE1394b Driver for Macintosh
This driver is for the P2 card on this unit.
By installing this driver, it is possible to connect to
this unit to the Macintosh using IEEE1394b
(Firewire 800) to transfer data at a higher rate.
Installation of the IEEE1394b driver
For the driver installation procedure, refer to
"2. Installation of the P2 Software" in the
installation manual in the Manuals folder on the
CD-ROM.
<Note>
Reinsert the P2 card if the P2 card icon is not
displayed.
<Reference>
Occasionally, a message regarding "Device
Removal" may be displayed when the P2 drive is
connected and the Macintosh is turned on.
The same message may also be displayed when
reinserting the P2 card because the P2 card icon
is not displayed, but this is not a malfunction.
Click "OK" and proceed to use the card.
18
Advertisement
Table of Contents
