Position Mode; Reharge Your Arlo Pro Battery - NETGEAR ARLO PRO User Manual

Position Mode

Position mode is available only when the camera is not streaming, recording motion,
or in Motion Detection mode.
¾ To place your camera in Position mode:
1. Tap the Arlo icon
If you are using a computer, enter
browser.
If you are using a mobile device that supports Touch ID, you are prompted to
enable Touch ID or skip.
2. Tap or click Settings.
The Settings page displays.
3. Under Camera Settings, select the camera to position.
4. Tap or click Position Mode.
The camera starts streaming video.
Note:
In Position mode, the camera streams video as fast as possible, without buffering,
so that you can aim the camera while watching on a smartphone and make near real-time
adjustments to the camera position. This means that you might see lower-quality video
while the camera is in Position mode.
Recharge Your Arlo Pro Battery
The Arlo Pro battery is fully charged when it leaves the factory.
¾ To recharge the battery:
1. Place the camera indoors.
If you are using the camera outside, bring it inside while charging the battery.
2. Connect the power adapter cable to the camera power adapter.
Note: You must use an Arlo Pro power adapter to charge the battery.
Set Up Your System
on your mobile device.
arlo.netgear.com
15
in the address bar of a