Security Menu; Password; Password Change; Text Display - Panasonic PT-FW300E Operating Instructions Manual

SECURITY menu

Remote control
See "Navigating through the menu" on page 34.
See "Main menu and Sub-menu" on page 32.
Entering the SECURITY menu
Every time when you apply to the SECURITY
menu, you will be asked to perform the password
operation.
PICTURE

PASSWORD

POSITION

PASSWORD CHANGE

LANGUAGE

TEXT DISPLAY

DISPLAY OPTION

TEXT CHANGE

PROJECTOR SETUP
MENU LOCK
SECURITY
MENU LOCK PASSWORD
NETWORK
CONTROL DEVICE SETUP
PASSWORD
RETURN
ENTER
When you apply to the SECURITY menu before you
change the password to your original, perform to input
the following factory default password operation.
Press F H G I F H G I and the ENTER button.
After you change the password
When you apply to the SECURITY menu after you
change the password to your original in the
PASSWORD CHANGE menu, input the original
password operation.
NOTE:
• The factory default password is valid until you change
the password in PASSWORD CHANGE menu.
• The entered password operations will appear as
asterisks in the box.
PASSWORD
You can activate the security system and the password
operation will be asked to perform when the projecting
mode started. Unless you perform the correct password
operation, all of the button controls will be disabled
except the power button.
OFF
ON
NOTE:
• When you activated the security system, make sure to
change the password to your original for safety.
• The factory default password is valid until you change
the password in PASSWORD CHANGE menu.
E
NGLISH - 46
Control panel
OFF
OFF
OFF
Deactive
Active
PASSWORD CHANGE
You can change the password operation to your original.
1. Press a series of button operation up to 8 as a
password by using F G I and H.
2. Press the ENTER button.
3. Press the exact same series of button operation
you entered in the NEW password box for
confirmation.
If a series of button operation is incorrect, you will be
asked to perform again.
4. Press the ENTER button.
NOTE:
• The entered password operations will appear as
asterisks in the box.
TEXT DISPLAY
You can set your original text, such as company name or
URL information, to display regularly at the bottom of the
projected image while projecting.
OFF Deactive
ON Active
TEXT CHANGE
You can enter your original text up to 22 characters for
TEXT DISPLAY.
TEXT CHANGE
OK
1. Enter your original text.
Use F G I H to specify the location of the required
character.
Move the cursor to ALL DELETE and press the
ENTER button to delete all the entered text line.
Press the DEFAULT button to delete the last entered
character or indicated with the cursor in the text line.
To insert a character in the entered text line, move
the cursor to the text box to select the required place
and press G then perform step 2.
2. Press the ENTER button.
The selected character will be displayed in the TEXT
CHANGE box.
3. Repeat until finish your original text.
4. Select OK and press the ENTER button to set the
entered text.
Select CANCEL or press the MENU/RETURN
buttons to return to the previous menu.
ALL DELETE
SPACE
CANCEL