Dvi-D In Terminal; Ceiling Mount Bracket Safeguards - Panasonic PT-FW300E Operating Instructions Manual

Technical Information

DVI-D IN terminal

Pin assignments and signal names

Ceiling mount bracket safeguards

The projector and the ceiling mount bracket are designed sufficiently safety though, make sure the safety cable
provided with the projector is installed and attached to the bottom of the projector when mounting on the ceiling for
safety and security.
NOTE:
• Even if it is guarantee period, the manufacturer is not responsible for any hazard or damage caused by using a ceiling
mount bracket which is not purchased from an authorised distributors, or environmental conditions.
• Make sure to use a torque driver and do not use an electrical screwdriver or an impact screwdriver.
• Installation work of the ceiling mount bracket should only be carried by a qualified technician.
• Remove an unused ceiling mount bracket promptly.
Installing the safety cable
1. Install the ceiling mount bracket according to the installation instructions.
2. Loop the security cable around the ceiling mount bracket with less slack.
Lace the cable of the end with a latch through the loop on the other end of the cable.
3. Attach the latch on to the bottom of the projector with a provided screw.
Torque: 1.25±0.2 N·m
* Indicated sample above is ET-PKF100S.
E
NGLISH - 58
Pin No. Signal name
1 TMDS Data 2-
2 TMDS Data 2+
TMDS Data 2/4
3
shield
4
5
6 DDC clock
7 DDC data
8
9 TMDS Data 1-
10 TMDS Data 1+
TMDS Data 1/3
11
shield
12
Pin No. Signal name
13
14 +5V
15 GND
16 Hot Plug Detect
17 TMDS Data 0-
18 TMDS Data 0+
TMDS Data 0/5
19
shield
20
21
22 TMDS clock shield
23 TMDS clock+
24 TMDS clock-