Powering Off The Projector - Panasonic PT-DW100U Operating Instructions Manual

3
4

Powering off the projector

1 Press POWER STANDBY " ".
• A confirmation screen will appear.
POWER OFF
OK
CHANGE
EXECUTE
ENTER
2 Press ◄ or ► to select "OK" and
press ENTER.
(or press POWER STANDBY " "
again.)
• The projection of the image stops, and the
power indicator lamp of the main unit lights up
orange. (The cooling fan keeps running.)
3 Wait until the power indicator
lamp of the main unit turns to
red (i.e., until the cooling fan
stops). (Approx. 3 minutes)
• While the cooling fan is still running, never turn
off the MAIN POWER switch, nor unplug the
projector from the outlet.
4 Press the "○" marked side of the
MAIN POWER switch to remove
all power from the projector.
1
•
•
CANCEL
•
2
Note
In the cooling state after the power is turned off, the
lamp will not light up even if the power is turned on.
To light up the lamp, turn on the power supply again
when the lamp has been cooled sufficiently.
The projector consumes approximately 15 W (240 V
mode) and 10 W (120 V mode) of power even in
standby mode. (Power indicator lamp lit in red)
If the main power is mistakenly turned off during
use, the lamp may not relight after power is
restored. Please wait a few moments, then try
again.
1
2
ENGLISH – 37