Auto Signal; Large Screen Correction - Panasonic PT-DW100U Operating Instructions Manual
3-chip dlp-based projector commercial use
Hide thumbs
Also See for PT-DW100U:
- Specifications (4 pages) ,
- Operating instructions manual (132 pages) ,
- Service manual (240 pages)
Table of Contents
Advertisement
Display Option settings (continued)
10.
Press ENTER.
•
The "TARGET DATA" screen will be displayed.
TARGET DATA
RED
GREEN
BLUE
CYAN
MAGENTA
YELLOW
Press ▲▼ to select the desired
11.
colors, and press ◄► to input
their coordinates. The effects
can be confirmed on the
colorimeter.
12.
After all the data has been input,
press MENU.
Note
•
If "709MODE" has been selected as the "COLOR
MATCHING" setting, the 3 primary colors defined
by the ITU-R BT.709 standard will be set as the
target data.
•
If the target data is outside the color range of the
projector, the colors will not be projected correctly.
Large Screen Correction
When viewing images close up on a large screen,
you can correct the colors that appear lighter on the
screen so that they appear the same as the colors
that would appear on a normal-sized screen.
Press ▲▼ to select "LARGE
1.
SCREEN CORRECTION".
COLOR MATCHING
LARGE SCREEN CORRECTION
RGB IN
Press ◄► to switch "LARGE
2.
SCREEN CORRECTION".
•
The setting will change as follows each time
◄► is pressed.
OFF (No correction)
70 – ENGLISH
x
0.64
y
0.33
x
0.3
y
0.6
x
0.15
y
0.6
x
0.225
y
0.329
x
0.321
y
0.154
x
0.419
y
0.505
OFF
OFF
1 (Low)
2 (High)
RGB IN (Only RGB input)
When unregistered signals are to be input frequently
1/2
because the unit is used at conferences or other
venues, the screen display position can be adjusted
automatically without having to press AUTO SETUP
on the remote control each time.
Use this setting when adjusting a specific or oblong
(16:9, etc.) signal.
Press ▲▼ to select "RGB IN".
1.
LARGE SCREEN CORRECTION
RGB IN
DVI-D IN
2.
Press ENTER.
•
The "RGB IN" screen will be displayed.
RGB IN
AUTO SIGNAL
AUTO SETUP
AUTO SIGNAL
Press ▲▼ to select "AUTO
3.
SIGNAL".
Press ◄► to switch "AUTO
4.
SIGNAL".
•
The setting will change as follows each time
◄► is pressed.
OFF
•
If unregistered signals are input when "ON"
is selected, auto setup will be initiated
automatically.
AUTO SETUP
Press ▲▼ to select "AUTO
5.
SETUP".
6.
Press ENTER.
•
The "AUTO SETUP" screen will be displayed.
AUTO SETUP
MODE
Press ◄► to switch "MODE".
7.
•
The setting will change as follows each time
◄► is pressed.
DEFAULT
OFF
OFF
ON
DEFAULT
WIDE
USER
Advertisement
Chapters
Table of Contents
