Detaching And Refitting The Drum Unit And Developer - Kyocera FS-C8026N Service Man

(2) Detaching and refitting the drum unit and developer

<Procedure>
1. Remove the process unit (See page 1-6-13).
2. Remove two screws and then remove the
drum front plate.
3. Remove the front DS spring (Long) and the
rear DS spring (Short) from the front side
and the rear side of the process unit (bottom
side).
Drum front plate
Long
DS front spring
Process unit
Screws
Figure 1-6-21
Process unit
(bottom)
Short
DS rear spring
Figure 1-6-22
2BF
1-6-15