Dan D'Agostino Monoblock amplifier Owner's Manual

Dan D'Agostino Monoblock amplifier Owner's Manual

Progression monoblock amplifier

Advertisement

Quick Links

PROGRESSION
MONOBLOCK
AMPLIFIER
OWNER'S MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Monoblock amplifier and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Dan D'Agostino Monoblock amplifier

  • Page 1 PROGRESSION MONOBLOCK AMPLIFIER OWNER’S MANUAL...
  • Page 2 A note from Dan D’Agostino FOUNDER AND CHIEF DESIGNER OF DAN D’AGOSTINO MASTER AUDIO SYSTEMS Thank you for purchasing the Progression monoblock amplifiers. I am thrilled with the performance and aesthetic design of the Progression Mono amplifier. This design combines two normally exclusive traits: remarkable power output and exquisite musical finesse.
  • Page 3: Unpacking And Installation

    The information in this manual is the sole property of Dan D’Agostino Master Audio Systems. If you should need to send the Progression monoblock amplifier back to us for service, be sure Any reproduction in whole or part without the expressed written permission of Dan D’Agostino to use the original box and materials for shipment.
  • Page 4: Front Panel

    MAKING CONNECTIONS TO THE AMPLIFIER Speaker cables Install the speaker cables first. We recommend the use of high-quality cables terminated with spade or ring lugs that will fit the Progression’s binding posts. We advise against the use of pin connectors, banana plugs or bare-wire connections. Note that the positive (+) binding post has a red ring and the negative (-) binding post has a black ring.
  • Page 6: Operation

    OPERATION TROUBLESHOOTING Initial power-up of the amplifier Amplifier will not power up Move the rear panel power breaker switch to the up position to place the amplifier in standby If the front meter is not illuminated, follow the procedure outlined below. If one step succeeds mode.
  • Page 7 Sound comes from only one channel Follow the below steps in order. If one of these steps succeeds in restoring the sound, stop there and ignore the other steps. Check to make sure the power meters on both amplifiers are illuminated. If one amplifier’s meter is not illuminated, follow the troubleshooting steps under “Amplifier will not power up”...
  • Page 8: Limited Warranty

    It is important that you register your Progression monoblock amplifier with us online at www.dandagostino.com. For questions on warranty and service matters, contact Dan D’Agostino...
  • Page 9 BUILT BY HAND IN THE USA USING USA MACHINISTS, VENDORS AND PARTS PROCUREMENT. For more information about Dan D’Agostino Master www.dandagostino.com Audio Systems, please visit: ©2016 DAN D’AGOSTINO MASTER AUDIO SYSTEMS. ALL RIGHTS RESERVED.

Table of Contents