Temp And Lamp Indicators; Controlling Alerts - Panasonic PT-AE1000E Operating Instructions Manual

Hide thumbs Also See for PT-AE1000E:
Table of Contents

Advertisement

TEMP and LAMP Indicators

Controlling alerts

If a problem should occur with the projector, the TEMP and/or LAMP indicators will alert you. Respond to the alert
as follows.
1. Confirm the POWER indicator status and turn off the projector in the proper way.
2. Find out the cause of the problem.
3. Follow the instructions for each indication below and solve the problem.
4. Turn on the projector in the correct way and confirm the indicator is not indicating a problem any longer.
NOTE:
If no problem is found or the problem remains, do not turn on the projector. Instead contact an Authorised
Service Centre.
TEMP indicator
Indicator and
projector
Problem
Cause
Remedy
LAMP indicator
Indicator
Problem
Cause
Remedy
40 - E
NGLISH
Illuminating RED and still projecting
Flashing RED and POWER is turned off
The temperature inside and/or outside the projector is abnormally high.
The ventilation ports are
covered.
Remove the object(s) from
the ventilation ports or clear
around the projector.
Illuminating RED
LAMP RUNTIME has reached 1 800 hours
(with LAMP POWER set to NORMAL).
Lamp unit will run out soon and needs to be
replaced.
Replace the Lamp unit. See "Before
replacing the Lamp unit" on page 42.
LAMP indicator
TEMP indicator
The room temperature is too
high.
Reinstall the projector at a
temperature controlled place.
See "Setting up" on page 14.
Flashing RED
LAMP circuit failure, abnormal function or
LAMP is damaged.
The projector is switched off incorrectly.
Let the LAMP cool down and turn on the
projector.
If the POWER does not turn on, contact an
Authorised Service Centre.
The Air filter is excessively
dirty and the ventilation is
poor.
Clean or replace the Air filter
in the proper way. See
"Cleaning the Air filter" on
page 41.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents