Fcc Statement - FBII XL-4B Hookup And Installation Instructions

IIFEDERAL COMMUNICATIONS
COMMISSION (FCC) STATEMENT"
This equipment has been tested to FCC requirements and
has been found acceptable for use.
The FCC requires the following statement for your information.
This equipment generates and uses radio frequency energy and if not installed and used
properly, that is, in strict accordance with the manufacturer's instructions may cause interference
to radio and television reception. It has been tested and found to comply with the limits of Part
15 of FCC Rules, which are designed to provide reasonable protection against such inter-ference
in a residential installation. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
* If using an indoor antenna, have a quality outdoor antenna installed.
Reorient the receiving antenna until interference is reduced or eliminated.
Move the radio or television receiver away from the control/communicator.
Move the
antenna leads away from any wire runs to the control/communicator.
Plug the control/communicator into a different outlet so that it and the radio or
television receiver are on different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for
additional suggestions.
The user may find the following booklet prepared by the Federal Communications Commission
helpful:
"Interference Handbook"
This booklet is available from the U.S. Government Printing Office, Washington, DC 20402. Stock
No. 004-000-00450-7.
The user shall not make any changes or modifications to the equipment unless authorized by the
Installation Instructions or User's Manual. Unauthorized changes or modifications could void the
user's authority to operate the equipment.
IN THE EVENT OF TELEPHONE OPERATIONAL PROBLEMS
In event of telephone operational problems, disconnect the communicator by removing the plug
from the RJ31 X jack. We recommend that the installer demonstrate disconnecting the phones on
installation of the system. Do not disconnect the phone connection inside the com-munciator.
Doing so will result in the loss of the phone works correctly afier the communicator has been
disconnected from the phone lines, the communicator has a problem and should be returned for
repair.
If upon disconnection of the communicator, there is still a problem on your line, noti~ the
telephone company that they have a problem and request prompt repair service. The user may
not under any circumstances (in or out of warranty) attempt any service or repairs on the system.
It must be returned to the factory or an authorized sem,ice agency for all repair.
XL-4 HOOKUP & INSTALLATION Page 42