P" Position Switch - Toyota 2006 Prius Owner's Manual

B. Stopping procedure
(1) Stop your Prius completely by de-
pressing the brake pedal and then ap-
ply the parking brake.
(2) Press the "P" position switch. The in-
dicator on the switch comes on and
transaxle is locked to "P".
Note:
Be sure to put the hybrid transaxle into "P"
when parking.
During traffic jams, use the "D" position and
continue driving in that position. The battery
cannot be charged in "N".
When releasing the accelerator pedal in "B",
engine braking will be applied stronger than
in "D". Compared with ordinary vehicles,
you may feel less powerful engine braking
during high speed driving.
For environment friendly and economical driving
(1) Avoid abrupt acceleration or deceleration. This will ensure that sufficient
power supply remains in the hybrid battery and will enable you to drive
efficiently.
(2) Check the tire inflation pressure frequently to keep it at the proper level.
Note:
Trip information (Consumption, energy monitor) can be shown in the multi- informa-
tion display. Use this information for driving with good fuel economy. To see the
information, press "INFO" (located outside the display) and touch "Trip Info."
(located inside the display).
Printed in Japan 01- 0511- 00
On the side of the rear right seatback,
there is an air vent provided to cool the
hybrid battery. Do not put luggage or block
the vent. If the vent is covered, the hybrid
battery will overheat, and this may cause
lower vehicle output and reduced perfor-
mance.
— See Owner's Manual for details —
( U
C
Information Guide
1
2
01999- 47536
U 5