Ipv6 Configuration - HP 501 Configuration And Administration Manual

Static IP configuration
You can manually assign an IP address to the Ethernet port. This requires that you also define
the address of the default gateway and DNS server that are in use on your network.
Connection type
Select Static IP from the list to manually configure an IPv4 Ethernet address.
Static IP address
Set an address that is on the same subnet as the network to which the HP 501 will connect
when installed. Respect any DHCP server-mandated static address ranges.
Subnet mask
Specify the mask for the IP address.
Default gateway
Set the IP address of the gateway on the network.
DNS nameservers
Select Dynamic to have the DNS nameservers assigned through DHCP, or select Manual to
configure up to two static DNS nameserver addresses.

IPv6 configuration

If the attached network uses the IPv6 protocol, you can use the IPv6 configuration section
of the page to enable IPv6 support on the HP 501. IPv6 functionality is enabled by default.
IPv6
Enable or disable the ability to use IPv6 addressing to access the web user interface for
HP 501 configuration. This setting does not enable or disable IPv6 functionality on the network
itself.
Static IPv6 address
The HP 501 can have a static IPv6 address, even if addresses have already been configured
automatically. Enter an address in the form XXXX:XXXX:XXXX:XXXX.
36 Network configuration