Entering Pin-Code; Motion Sensor; Level Sensor - DEFA DVS90 Installation Manual

ENGLISH

Motion Sensor

Place the motion sensor above the rear mirror with the sensor facing the interior of the car. In
some cargo vans one might install more than one motion sensor, usually one in the drivers
cabin and one in the cargo room. If there is a metal wall dividing the two compartments the
sensors can be placed close to each other. However, if there is no metal wall dividing them,
the two sensors must be placed a minimum of 1,6 meters apart. (See figure).
Min distance:
1,6 meter
Connect the sensor to the LIN bus (P6 or P7).
The sensor sensitivity can be adjusted using the DEFA Express program. If the installation
is following a specific car installation guide, the sensitivity is already set to the right value for
that car.

Level Sensor

The level sensor can be placed in any direction. The sensor stores its position when the alarm
is armed.
The level sensor should be mounted firmly to a solid part of the car under the dashboard,
preventing it to move out of place.
Connect the sensor to the LIN bus (P6 or P7).
Normally the sensor sensitivity does not need any adjustments, but if the car is fitted with sport
suspension the sensitivity might have to be adjusted using the DEFA Express program.

ENTERING PIN-CODE

1. Turn the ignition on.
2. Press the button on the Window Module as many times as the first digit.
3. Wait (approx. 1 second) for the LED to blink once. This indicates that the digit is stored.
4. Repeat steps 2 and 3 with the remaining digits. When the last digit is stored the LED will
flash rapidly to indicate that the correct PIN is entered.
5. If at any point you enter a wrong digit you may start over from step 2 as many times as
required.
70