Bushnell Trophy Cam Agressor 11977 Instruction Manual page 27

MOUNTING and POSITIONING the Trophy
Cam HD Aggressor
Mounting
After you've set up the camera's parameters to your personal preferences
at home or in your truck, you're ready to take it outside and slide the power
switch to "ON". When setting up the Trophy Cam HD Aggressor for
scouting game or other outdoor applications, you must be sure to mount it
in place correctly and securely. We recommend mounting the Trophy Cam
HD Aggressor on a sturdy tree with a diameter of about 6 in. (15cm). To get
the optimal picture quality, the tree should be about 16-17 ft. (5 meters) away
from the place to be monitored, with the camera placed at a height of 5-6.5
ft. (1.5~2 m). Also, keep in mind that you will get the best results at night
when the subject is within the ideal flash range, no farther than 80ft/24m
(119776/119777) or 100ft/30m (119774/119775) and no closer than 10ft
(3m) from the camera.
There are two ways to mount the Trophy Cam HD Aggressor: using the
provided adjustable web belt, or the tripod socket:
Using the adjustable web belt: Fig. 5 illustrates using the web belt on the
Trophy Cam HD Aggressor. Push one end of the belt through the two
brackets on the back of the Trophy Cam HD Aggressor. Thread the end
of the strap through the buckle. Fasten the belt securely around the tree
trunk by pulling the end of the strap firmly so there is no slack left. Note: it
is not possible to use a cable lock (in the upper part of the bracket) and
the web belt at the same time.
Using the tripod socket: The camera is equipped with a socket at the
bottom end to enable mounting on a tripod or other mounting accessories
with a standard1/4-20 thread.
Fig. 5: Attaching the Belt
Belt Channel
Strap Buckle
27