Bushnell Trophy Cam Agressor 11977 Instruction Manual page 13

USING THE SETUP MENU TO CHANGE SETTINGS
The main purpose of the SETUP mode is to allow you to change the settings
of the camera's parameters (19 different ones are available!) so your Trophy
Cam HD Aggressor operates exactly the way you want it to. You will do this
by entering the SETUP Menu and pressing the keys below the LCD display,
which will show you each parameter and its setting.
Changing Parameter Settings in SETUP Mode
A wide range of options or "parameters" are provided to allow you to set the
Trophy Cam HD Aggressor to your operational preferences. To change
the setting of any parameter you must first switch to the SETUP mode.
Once in SETUP mode, pressing the MENU button will allow you to select
any parameter and change its setting. The name of the parameter and its
current setting will be shown on the LCD. Pressing the RIGHT or LEFT
key scrolls to the next or previous parameter (RIGHT key to move on to
the next parameter and LEFT key to go back to the previous parameter),
and pressing the UP or DOWN key lets you select a different setting for
the currently displayed parameter. Once you have selected your preferred
new setting for a parameter, press the OK button to save the new setting
(actually change it). When you are finished changing the settings of one or
more parameters, press MENU again to exit the SETUP menu. MENU can
also be pressed anytime you want to cancel changing a parameter's setting
after a new setting has been selected (but OK has not been pressed yet).
After setting the parameters to your preferences, be sure to move the switch
to ON to begin actually taking photos or videos. No images will be captured
if the switch is left in the SETUP position (unless you press the RIGHT/Shot
key after exiting the menu)-in fact, the camera will power off automatically after
a few minutes with no key pressed.
Parameter Settings Display
The settings for each parameter are shown on the display screen of your
Trophy Cam HD Aggressor. Only one setting is displayed at a time,
starting with the current setting for the parameter when it is first selected (pg.
14, Fig. 4a). To change the setting, use the UP/DOWN keys to display the
new setting you want (Fig. 4b), then press OK to "Execute" (make the actual
change to this setting). If you want to confirm this setting is now the current
one, just press the RIGHT key to scroll to the next parameter, then press
LEFT to go back again to the previous one. You should see the parameter
setting you just made.
13