Stihl HT 131 Instruction Manual page 9

Position the cutting attachment with the
hook against the branch and then
perform the cross-cut. This reduces the
risk of the pruner being jerked forward
as you start the cross-cut.
Always start the cut with the engine at
full throttle.
Always cut with a correctly sharpened,
properly tensioned chain – the depth
gauge setting must not be too large.
Do not operate your power tool in the
starting throttle position – engine speed
cannot be controlled in this position.
Perform cross-cut from the top
downward to avoid the chain pinching in
the cut.
If branch is thick or heavy, make a
relieving cut – see chapter on "Using the
Pole Pruner".
To reduce the risk of injury, take special
care when cutting branches under
tension. Always make a relieving cut on
the compression side first and then
perform the bucking cut at the tension
side.
To reduce the risk of injury, take special
care when cutting shattered wood
because of the risk of injury from slivers
being caught and thrown in your
direction.
HT 100, HT 101, HT 130, HT 131
If on a slope, stand on the uphill side or
to one side of the branch to be cut.
Watch out for rolling branches.
Note when reaching the end of a cut that
the unit is no longer supported by the
guide bar in the cut. You have to take the
full weight of the machine since it might
otherwise go out of control.
Always pull the unit out of the cut with
the chain running.
To reduce the risk of accidents, use your
pole pruner for limbing and pruning only.
It is not designed for felling.
Make sure your saw chain does not
touch any foreign materials: Stones,
nails, etc. may be flung off and damage
the saw chain.
If the rotating chain makes contact with
a rock or other solid object there is a risk
of sparking which may cause easily
combustible material to catch fire under
certain circumstances. Dry plants and
scrub are also easily combustible,
especially in hot and dry weather
conditions. If there is a risk of fire, do not
use your pole pruner near combustible
materials, dry plants or scrub. Always
contact your local forest authority for
information on a possible fire risk.
Before leaving the power tool
unattended: Shut off the engine.
Vibrations
Prolonged use of the power tool may
result in vibration-induced circulation
problems in the hands (whitefinger
disease).
No general recommendation can be
given for the length of usage because it
depends on several factors.
The period of usage is prolonged by:
Hand protection (wearing warm
–
gloves)
Work breaks
–
The period of usage is shortened by:
Any personal tendency to suffer
–
from poor circulation (symptoms:
frequently cold fingers, tingling
sensations).
Low outside temperatures.
–
The force with which the handles
–
are held (a tight grip restricts
circulation).
Continual and regular users should
monitor closely the condition of their
hands and fingers. If any of the above
symptoms appear (e.g. tingling
sensation in fingers), seek medical
advice.
Maintenance and Repairs
Service the machine regularly. Do not
attempt any maintenance or repair work
not described in the instruction manual.
Have all other work performed by a
servicing dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer. STIHL dealers are
regularly given the opportunity to attend
training courses and are supplied with
the necessary technical information.
English
7