Pto Shaft Cover And Shaft Cap; Stationary Pto - Kubota B2920 Operator's Manual

30 PTO
BPTO shaft Cover and Shaft Cap
Keep the PTO shaft cover in place at all times. Replace
the PTO shaft cap when the PTO is not in use. Before
connecting or disconnecting a drive shaft to PTO shaft, be
sure engine is "OFF" and raise up the PTO shaft cover.
Afterward be sure to return the PTO shaft cover to the
"NORMAL POSITION".
(1) PTO shaft cover
(2) PTO shaft cap
(A) "NORMAL POSITION"
(B) "RAISED POSITION"
BStationary PTO
To park the tractor and use the PTO system (for chipper
or pump, for example), start the PTO system in the
following steps.
1. Apply the parking brakes and place blocks at the tires.
2. Make sure the shift levers are at NEUTRAL, and start
the engine.
3. Set the PTO gear shift lever to "Rear PTO 1st"
position.
4. Set the engine speed to provide recommended rear
PTO speed.
5. Dismount the seat and tilt up quickly (engine will stop
if there is a delay in tilting up the seat).
(1) Seat
(2) Clutch pedal
(3) PTO gear shift lever
A If the PTO system is engaged and you stand up from
the seat or the seat is not tilted forward, the engine
stops automatically after standing up.
(A) Rear PTO "1st"
Mid PTO "OFF"
(N) "NEUTRAL POSITION"