Range Gear Shift Lever (L-M-H) [Hst Type]; Main Gear Shift Lever & Range Gear Shift Lever (L-M-H) [Manual Transmission Type] - Kubota B2920 Operator's Manual

22 OPERATING THE TRACTOR
A Avoid operating the tractor with your foot resting on
the clutch pedal.
A Select proper gear and engine speed depending
on the type of job.
6. Selecting the Travel Speed.
BRange Gear Shift Lever (L-M-H) [HST
Type]
The range gear shift can only be shifted when tractor is
completely stopped and the clutch pedal is depressed.
(1) Range gear shift lever
(L-M-H)
Depress the clutch pedal and stop the tractor.
Do not force the range gear shift lever.
A If it is difficult to shift the range gear shift lever into
neutral position;
(1) Depress the brake pedals firmly for several
seconds.
(2) Without reducing the brake pedal force, depress
the clutch pedal and then shift the range gear shift
lever.
A If it is difficult to shift the range gear shift lever into "L",
"M" or "H" from neutral position;
(1) Release the clutch pedal.
(2) Slightly depress the speed control pedal to rotate
the gears inside of transmission.
(3) Release the speed control pedal to neutral
position.
(4) Depress the clutch pedal and then shift the range
gear shift lever.
(H) "HIGH"
(M) "MIDDLE"
(L) "LOW"
(N) "NEUTRAL POSITION"
BMain Gear Shift Lever & Range Gear Shift
Lever (L-M-H) [Manual Transmission
Type]
The main gear shift lever pattern is in the form of an "H".
The range gear shift lever moves in the form of an "I" in 3
stages, "HIGH", "MIDDLE" and "LOW". By combination of
using the main gear shift lever and the range gear shift
lever, 9 forward speeds and 3 reverse speeds are
obtained.
(1) Main gear shift lever
(2) Range gear shift lever
(L-M-H)
A To change speeds, press the clutch pedal completely
down and stop the tractor before attempting to
proceed with speed change.
A When you stand up from the seat with the main gear
shift lever at engaged, the engine will stop regardless
of whether the machine is moving or not.
This is because the tractor is equipped with Operator
Presence Control system (OPC).
(H) "HIGH"
(M) "MIDDLE"
(L) "LOW"
(N) "NEUTRAL POSITION"