Checking And Refueling; Checking Engine Oil Level - Kubota B2920 Operator's Manual

Hide thumbs Also See for B2920:
Table of Contents

Advertisement

BChecking and Refueling
To avoid personal injury:
A Do not smoke while refueling.
A Be sure to stop the engine before refueling.
1. Turn the key switch to "ON", check the amount of fuel
by fuel gauge.
2. Fill fuel tank when fuel gauge shows 1/4 or less fuel in
tank.
(1) Fuel tank cap
Fuel tank capacity
A Do not permit dirt or trash to get into the fuel system.
A Be careful not to let the fuel tank become empty,
otherwise air will enter the fuel system, necessitating
bleeding before next engine start.
A Be careful not to spill during refueling. If should spill,
wipe it off at once, or it may cause a fire.
A To prevent condensation (water) accumulation in the
fuel tank, fill the tank before parking overnight.
26 L (6.9 U.S.gals.)
BChecking Engine Oil Level
To avoid personal injury:
A Be sure to stop the engine before checking the
oil level.
1. Park the machine on a flat surface.
2. Check engine oil before starting the engine or 5
minutes or more after the engine has stopped.
3. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the two notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS" in "MAINTENANCE" section.)
(1) Oil inlet
(A) Oil level is acceptable within this range.
(2) Dipstick
A When using an oil of different maker or viscosity from
the previous one, remove all of the old oil and oil filter.
Never mix two different types of oil.
A If oil level is low, do not run engine.
PERIODIC SERVICE
51

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

B2620B2320B2320narrow

Table of Contents