Installing The Battery - Lionel AC6000 Owner's Manual

LEGACY RailSounds sound system operations

Installing the battery

W
hile the LEGACY RailSounds sound system is powered through the track, we recommend
that you install a nine-volt alkaline battery to prevent the sound system from shutting
down during track power interruptions (for example, at a switch or a dirty section of track).
Follow these steps and refer to Figure 3 as you install the battery.
Note! If the LEGACY RailSounds sound system turns off during interruptions in track
power, you may need to replace the battery.
1. Carefully lift up and remove the rear radiator vent.
2. Remove the protective cover from the battery harness.
3. Snap the battery harness onto the nine-volt alkaline battery's terminals.
4. Slide the battery into the battery clip.
5. Replace the rear radiator vent.
REAR
Battery
harness
Nine-volt
alkaline
battery
Battery
holder
Inside the locomotive
Figure 3. Battery installation and volume control knob location
Rear radiator vent
Volume control knob
0