Table of Contents
Advertisement
1.
Place a type "A" coal between the
front and rear base coals with the letter
"A" upright and so that the coal is
against the left side of the firebox. See
figure 7.
2.
Place a type "B" coal between the
front and rear base coals as shown in
figure 8. The letter "B" should be
upright.
3.
Place a type "A" coal between the
front and rear base coals with the
letter "A" upright. The top of the coal
should rest against the centre coal of
the rear base coal as shown in figure 9.
4.
Place the remaining type "B" coal
at the right side of the firebox between
the front and rear base coals. The
letter "B" should be upright. The coal
should touch the right side of the
firebox. See figure 10.
5.
Place the remaining type "A" coal
between the front and rear base coals.
The letter "A" should be upside down
with its rear face between the right
and centre coals of the rear base coal.
Angle the coal so that the gap
between it and the type "B" coal to
its right is appreciably larger than the
gap between it and the type "A" coal
to its left but do not have it touching
the type "A" coal. This will give the
best flame effect. See figure 11.
OWNER'S GUIDE
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Page 11
Advertisement
Table of Contents
