Lighting With A Taper; Cleaning; Metal Parts; Ceramic Fuel Effect Pieces And Burner Compartment Walls - Baxi 740FS Owner's Manual

quite normal.

Lighting with a taper.

(See figure 2).
In the unlikely event of failure of the ignition spark,
the pilot can be lit by a taper or long spill. Insert the
taper or spill between the second and third left hand
ceramic fuel effect pieces on the first row. Operate
the slide control as described above.
To maintain the high performance and quality finish of your fire please follow these
guidelines:
Before attempting to clean the fire, please remember to turn off the fire and wait for the
appliance to cool. The fire will retain heat for some time before cleaning can begin.
If any pieces of debris are found in the firebox, have the chimney inspected before
further use.

Metal parts.

Clean the metal parts with a slightly damp cloth and then dry.
!
Do not use abrasive cleaners as these will scratch the fire surface.
!

Ceramic fuel effect pieces and burner compartment walls.

This product uses fuel effect pieces and burner compartment walls containing
Refractory Ceramic Fibres (RCF), which are man-made vitreous silicate fibres.
Excessive exposure to this material may cause irritation to eyes, skin and
respiratory tract. Consequently, it is important to take care when handling these
articles to ensure that the release of dust is kept to a minimum.
Light coatings of soot will usually be burnt off during the normal operation of the
!
fire. Should any soot accumulation become excessive, the fuel effect pieces and walls
should be removed from the fire for cleaning.
Cleaning should be carried out in a well ventilated area or in the open air by gently
!
OWNER GUIDE
CLEANING YOUR FIRE
Page 8
Figure 2. Lighting with a taper
(The fuel effect may differ from
that shown)