Table of Contents
Advertisement
J) F_PANEL (2x7 pins jumper)
2
1
HD (IDE Hard Disk Active LED)
SPK (Speaker Connector)
RST (Reset Switch)
PD+/PD_G-/PD_Y-(Power LED) Pin 1: LED anode(+)
PW (Soft Power Connector)
Please connect the power LED, PC speaker, reset switch and power switch etc of your chassis
front panel to the F_PANEL connector according to the pin assignment above.
This Manual: http://www.manuallib.com/file/2596474
14
13
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal Operation
Close: Reset Hardware System
Pin 2: LED cathode(-)
Pin 3: LED cathode(-)
Open: Normal Operation
Close: Power On/Off
- 19 -
Hardware Installation Process
Advertisement
Table of Contents
