Table of Contents
Advertisement
Share Memory Size
4MB/8MB/16MB/32MB/64MB Set onchip VGA shared memory size.(Default Value:32MB)
USB Controller
Disable this option if you are not using the onboard USB feature.
Enabled
Disabled
USB Legacy Support
Enabled
Disabled
Onboard Lan
Disabled
Enabled
Init Display First
This feature allows you to select the first initation of the monitor display from which card, when you
install an AGP VGA card and a PCI VGA card on board.
PCI
AGP
OnBoard FDC
When enabled, the fioppy diskette drive (FDD) controller is activated.
Disabled
Enabled
Onboard Serial Port A
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
This Manual: http://www.manuallib.com/file/2596474
Enable USB Controller. (Default value)
Disable USB Controller.
Enable USB Legacy Support.
Disable this function.(Default Value)
Disable this function.
Enable Onboard Lan Chip function. (Default Value)
Set Init Display First to PCI Slot.
Set Init Display First to AGP. (Default value)
Disable this function.
Enable on board floppy disk controller.(Default value)
BIOS will automatically setup the port A address.
Enable onboard Serial port A and using daddress 3F8 , IRQ4. (Default Value)
Enable onboard Serial port A and using daddress 2F8 , IRQ3.
Enable onboard Serial port A and using daddress 3E8 , IRQ4.
Enable onboard Serial port A and using daddress 2E8 , IRQ3.
Disable onboard Serial port A.
- 35 -
BIOS Setup
Advertisement
Table of Contents
