Onboard Parallel Port; Parallel Port Mode - Gigabyte GA-8SIMLFS User Manual

Onboard Serial Port B
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Serial Port B Mode
(This item allows you to select the IR modes if the serial port B is used as an IR port.Set at Normal , if
you use COM2 as the serial port as the serial port, instead as an IR port.)
ASKIR
IrDA
Normal

OnBoard Parallel port

This feature allows you to select from a given set of parameters if the parallel port uses the onboard I/
O controller.
378/IRQ7
278/IRQ5
3BC/IRQ7
Disabled

Parallel Port Mode

This feature allows you to connect with an advanced print via the port mode it supports.
SPP
EPP
ECP
ECP+EPP
EPP Version
This feature allows you to select the EPP type version.
EPP 1.9
EPP 1.7
GA-8SIML Motherboard
This Manual: http://www.manuallib.com/file/2596474
BIOS will automatically setup the port B address.
Enable onboard Serial port B and using daddress 3F8 , IRQ4.
Enable onboard Serial port B and using daddress 2F8 , IRQ3. (Default Value)
Enable onboard Serial port B and using daddress 3E8 , IRQ4.
Enable onboard Serial port B and using daddress 2E8 , IRQ3.
Disable onboard Serial port B.
Set onboard I/O chip UART to ASKIR Mode.
Set onboard I/O chip UART to IrDa Mode.
Set onboard I/O chip UART to Normal Mode. (Default Value)
Enable On Board LPT port and using address 378, IRQ7.(Default Value)
Enable On Board LPT port and using address 278, IRQ5.
Enable On Board LPT port and using address 3BC, IRQ7.
Disable onboard Parallel port.
Using Parallel port as Standard Parallel Port.
Using Parallel port as Enhanced Parallel Port.
Using Parallel port as Extended Capabilities Port.(Default Value)
Using Parallel port as ECP & EPP mode.
Compliant with EPP 1.9 version.
Compliant with EPP 1.7 version.(Default Value)
- 36
-