Connecting; Antenna (Aerial) And Speakers - Onkyo FR-V3 Instruction Manual

Antenna (aerial) and speakers

Antenna (aerial) connection is a must for auto clock setting. Do not connect the AC
power cord (mains lead) at this time. The AC power cord will be connected on page
11.
Antenna (aerial) connector
Connecting the supplied indoor
antenna (aerial)
While listening to the radio on page 20, move the
antenna (aerial) in various directions until the clearest
signal is received. Then secure the antenna (aerial)
with push pins in the position with the least distortion.
To connect the outdoor antenna (aerial)
If signals received via the indoor antenna (aerial) are
not clear enough, connect an outdoor FM antenna
(aerial).
(Not supplied)
6

Connecting

ANTENNA
FM
75Ω
R L
LINE
IN-1
LINE
IN-2
OUTPUT
(REC)
TAPE
INPUT
(PLAY)
OPTICAL
DIGITAL INPUT
REMOTE
CONTROL
ANTENNA
FM
75Ω
R L
LINE
IN-1
LINE
IN-2
OUTPUT
(REC)
TAPE
INPUT
(PLAY)
OPTICAL
DIGITAL INPUT
ANTENNA
FM
75Ω
R L
LINE
IN-1
LINE
IN-2
OUTPUT
(REC)
TAPE
INPUT
(PLAY)
OPTICAL
DIGITAL INPUT
Speaker connectors
+ – – +
R L
SPEAKERS
CAUTION: SPEAKER IMPEDANCE
4 OHMS MIN. / SPEAKER
WARNING
Do not install the antenna (aerial) near power lines because
this could result in electrical shock.
Note
Keep the antenna (aerial) away from noise sources, such
as neon signs and busy roads.
Connecting the speakers
Right speaker Left speaker
– + – +
+ – –
R
SPEAKERS
CAUTION: SPEAKER IMPEDANCE
4 OHMS MIN. / SPEAKER
1 2
Press down Insert the
the lever. stripped end of
the cord.
(Speakers from behind)
1
15mm
Strip 15 mm from
the end of each
cord.
2
Twist the stripped
end of the cord.
+
L
3
Push the lever up.
The wire of the stripped
end of the cord should
appear slightly.