Preparations; Preparing The Remote Controller; Fr-V3 - Onkyo FR-V3 Instruction Manual

Preparing the remote controller

Inserting the batteries
1
2
3
Notes
• Do not mix new batteries with old batteries or different
kinds of batteries.
• To avoid corrosion, remove the batteries if the remote
controller is not to be used for a long time.
• Remove dead batteries immediately to avoid damage from
corrosion. If the remote controller does not operate
smoothly, replace both the batteries at the same time.
• The life of the batteries supplied is about six months but
this will vary depending on usage.
10

Preparations

Detach the battery
cover.
Insert the two R6
(size AA) batteries.
Be sure to match the
+ and – ends of the
batteries with the
diagram inside the
battery compartment.
Attach the battery
cover.
Using the remote controller
Point the remote controller toward the remote control
sensor.
30°
Notes
• Place the unit away from strong light such as direct
sunlight or inverted fluorescent light which can prevent
proper operation of the remote controller.
• Using another remote controller of the same type in the
same room or using the unit near equipment which uses
infrared rays may cause operational interference.
• Do not put any object such as a book on the remote
controller. The buttons of the remote controller may be
pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored glass.
Placing the unit behind such doors may prevent proper
remote controller operation.
• If there is any obstacle between the remote controller and
the remote control sensor, the remote controller will not
operate.
30°
Remote control
sensor