Computherm Q8RF(TX) Operating Instructions Manual page 9

Temperature
3.3 Programming steps
a. Press the "SET" button to go to the main screen.
b. Press the "SET" button again and hold it down and press the "PROG"
button, too. At this point the device gets into programming mode and the
abbreviations indicating the days of the week (
) are flashing on the display.
SAT SUN
c. Select the day to be programmed using the large
buttons on the front panel of the device (
indicating Tuesday etc.). If you wish to create the same program for
each day of the week, it is reasonable to choose all days of the week
simultaneously (by selecting
this way there is no need to perform separate programming of the days.
After selecting the desired day(s), press the "PROG" button.
d. At this point the temperature of switch
indicated on the display of the device by flashing the temperature value
to be set (
and
e. Then, the start time of switch
indicated on the display of the device by flashing the time value to be
adjusted (
buttons, then press the "PROG" button.
f. Following this, the temperature of switch
is indicated on the display of the device by flashing the temperature value
to be set (
using the large
g. The next step in programming is the adjustment of the start time of
switch
PROG
the time value to be adjusted (
of switches
is adjusted) by repeating the "e"-"f" steps.
by default). Set the desired temperature using the large
°C
buttons, then press the "PROG" button.
by default). Set the desired time using the large
by default). Set this temperature level of switch
°C
and
, which is indicated on the display of the device by flashing
‒
PROG PROG
MON
MON TUE WED THU FRI SAT SUN
PROG
should be adjusted, which is
PROG
PROG
buttons, then press the "PROG" button.
by default). The adjustment process
can be done (the same way as switch
- 9 -
program
number
MON TUE WED THU FRI
and
indicating Monday,
together),
should be set, which is
should be set, which
TUE
and
PROG
PROG