To activate the lock, first press the "SET" button to go to the main screen, then
press the
seconds. After the control buttons have successfully been locked, the notice
"
" appears in place of the time characters for a couple of seconds. Until
the control buttons are locked, their normal function do not work; if any button
is pressed, then only the notice "
To unlock press the
at least 5 seconds. After unlocking the buttons, the notice "
in place of the time characters for a couple of seconds, whereupon all the
buttons can be used normally again.
7. CHANGING THE BATTERY
The average lifetime of the batteries is 1 year, but frequent use of the back-
ground light may shorten this time considerably. If the
battery voltage appears on the display, the batteries should be replaced (see
Section 2.1). The exact time should be set again after the batteries have been
replaced, but the device saves the program that has been loaded even with-
out batteries therefore there is no need to reprogram the device.
8. RESETTING THE THERMOSTAT TO ITS FACTORY
DEFAULT SETTINGS
By pressing the "RESET" button located on the main panel of the thermostat,
the thermostat can be reset to its factory default settings. This results in
deleting the day, exact time, basic settings and the set program. After resetting
the device, adjust the basic settings of the thermostat again and create the
new program, as described in Sections 2 and 3.
9. TUNING THE
THERMOSTAT AND THE RECEIVER UNIT OF
COMPUTHERM Q8RF
THE
TOGETHER
COMPUTHERM
9.1
If you would like to use the
COMPUTHERM
ment the
steps described in Section 9.2 of the manual of the
thermostat.
and
buttons together and hold them down for at least 5
and
COMPUTHERM Q8RF(TX)
Q8RF(TX) -
COMPUTHERM
Q8RF multi-zone thermostat, then follow the tuning
" appears and nothing else happens.
buttons together and hold them down for
THERMOSTAT
COMPUTHERM
Q8RF(TX) thermostat to comple-
- 14 -
" appears
icon indicating low
Q8RF
COMPUTHERM
Q8RF
Need help?
Do you have a question about the Q8RF(TX) and is the answer not in the manual?
Questions and answers