System Profile Settings Details - Dell PowerEdge T130 Owner's Manual

Option Description
Redirection After Enables or disables the BIOS console redirection when the operating system is
Boot loaded. This option is set to Enabled by default.

System Profile Settings details

The System Profile Settings screen details are explained as follows:
Option Description
System Profile Sets the system profile. If you set the System Profile option to a mode other than
Custom, the BIOS automatically sets the rest of the options. You can only change
the rest of the options if the mode is set to Custom. This option is set to
Performance Per Watt (OS).
CPU Power Sets the CPU power management. This option is set to OS DBPM by default. DBPM
Management is Demand-Based Power Management.
Memory Sets the speed of the system memory. You can select Maximum Performance,
Frequency Maximum Reliability, or a specific speed.
Turbo Boost Enables or disables the processor to operate in the turbo boost mode. This option
is set to Enabled by default.
C1E Enables or disables the processor to switch to a minimum performance state when
it is idle. This option is set to Enabled by default.
C States Enables or disables the processor to operate in all available power states. This
option is set to Enabled by default.
Memory Refresh Sets the memory refresh rate to either 1x or 2x. This option is set to 1x by default.
Rate
Uncore Frequency Enables you to select the Processor Uncore Frequency option.
Dynamic mode enables the processor to optimize power resources across the
cores and uncore during runtime. The optimization of the uncore frequency to
either save power or optimize performance is influenced by the setting of the
Energy Efficiency Policy option.
Energy Efficient Enables you to select the Energy Efficient Policy option.
Policy
The CPU uses the setting to manipulate the internal behavior of the processor and
determines whether to target higher performance or better power savings.
Number of Turbo Controls the number of turbo boost enabled cores for processor 1. The maximum
Boot Enabled number of cores is enabled by default.
Cores for
Processor 1
Monitor/Mwait Enables the Monitor/Mwait instructions in the processor. This option is set to
Enabled for all system profiles, except Custom by default.
NOTE: All the parameters on the system profile setting screen are available
only when the System Profile option is set to Custom.
NOTE: This option can be disabled only if the C States option in the Custom
mode is set to disabled.
29