Troubleshooting A Nic; Troubleshooting A Wet System - Dell PowerEdge T130 Owner's Manual
Hide thumbs
Also See for PowerEdge T130:
- Owner's manual (119 pages) ,
- Getting started (2 pages) ,
- Owner's manual (120 pages)
Table of Contents
Advertisement
Troubleshooting a NIC
Steps
1.
Run the appropriate diagnostic test. For more information, see the Using system diagnostics section
for the available diagnostic tests.
2.
Restart the system and check for any system messages pertaining to the NIC controller.
3.
Check the appropriate indicator on the NIC connector:
•
If the link indicator does not glow, the cable connected might be disengaged.
•
If the activity indicator does not glow, the network driver files might be damaged or missing.
Install or replace the drivers as necessary. For more information, see the NIC documentation.
•
If the problem persists, use another connector on the switch or hub.
4.
Ensure that the appropriate drivers are installed and the protocols are bound. For more information,
see the NIC documentation.
5.
Enter System Setup and confirm that the NIC ports are enabled on the Integrated Devices screen.
6.
Ensure that all the NICs, hubs, and switches on the network are set to the same data transmission
speed and duplex. For more information, see the documentation for each network device.
7.
Ensure that all network cables are of the proper type and do not exceed the maximum length.
Next steps
If the problem persists, see the Getting help section.
Troubleshooting a wet system
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
1.
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2.
Remove the system cover.
3.
Remove the following components (if installed) from the system:
•
power supply unit(s)
•
optical drive
•
hard drives
•
hard drive backplane
•
USB memory key
•
hard drive tray
•
cooling shroud
•
expansion card risers (if installed)
•
expansion cards
•
cooling fan assembly (if installed)
•
cooling fans
95
Advertisement
Table of Contents
Troubleshooting
