Table of Contents
Advertisement
exec program
deleteallrois
deleteallrois MC_A
fitrois
fitrois MC_A
autocal
autocal MC_A
The following commands make sense only when using the serial line or TCP/IP control:
MC_A?
?
RROI(0,1)
ADC?
sendfile filename
The execution of a control file can be finished from the Server or MCDWIN with any Halt
command.
ComTec GmbH
Windows Server Program
; Executes a Windows program or .PIF file.
; Example: exec notepad test.ctl
; opens the notepad editor and loads test.ctl.
; Deletes all ROIs in the active Display of MCDWIN or the active
; multichannel analyzer if MCDWIN is not running.
; Similar to the deleteallrois command, but using the argument allows to
; specify which spectrum should be treated independently of
; which child window is activated in MCDWIN
; Makes a single peak Gaussian fit for all ROIs and dumps the result
; into a logfile. This is performed by the MCDWIN program and
; therefore can be made only if this application is running.
; Similar to the fitrois command, but using the argument allows to
; specify which spectrum should be evaluated independently of
; which child window is activated in MCDWIN.
; Makes a single peak Gaussian fit for all ROIs in the active Display of
; MCDWIN, for which a peak value was entered and uses the result for
; a calibration. This is performed by the MCDWIN program and
; therefore can be made only if this application is running.
; Similar to the autocal command, but using the argument allows to
; specify which spectrum should be evaluated independently of
; which child window is activated in MCDWIN.
; Sends the status of MC_A via the serial port and make MC_A
; actual.
; Send the status of the actual multichannel analyzer
; Sends the sum, mean value and max positive and negative
; deviation from mean of rectangular ROI #1 in spectra #0
; Sends the AXAS Status
; Sends the ASCII file with name 'filename' via the serial line.
4-8
Advertisement
Table of Contents
