Disk Brake Adjustment - Gamma 5003 Owner's Manual

DISK BRAKE ADJUSTMENT

Adjusting the Tensioner Brake
A
Step 1
A
After stringing many racquets, the brake of the tensioner
may need to be adjusted. The Brake Adjustment Bolt
B
can be accessed through the hole in the face of the
tensioner cover, which does not need to be removed for
adjustment. The Tensioner Cover has been removed in
the pictures for illustration purposes.
A - Cover Screws B - Lock Bolt
Step 2
With the brake lever engaged, loosen the lower hex bolt
located on the back side of the tensioner frame with the
10 mm box wrench. Note: The hex bolt should only be
loosened until loose enough to turned by hand and must
not be removed completely.
C
C - Brake Adjustment Bolt
Step 3
With the hex bolt loosened and the brake lever engaged
in the latch, insert the 6 mm hex wrench into the set
screw locted inside the nut located at the base of the
brake lever. To tighten the braking mechanism, turn the
set screw counter clockwise by about 1/8 turn. Re-
tighten the hex bolt on the back side of the tensioner
frame and check for brake tightness. The tensioner
should move freely along the track with the brake lever
engaged and should hold tension with the brake lever
released. If more adjustment is needed, repeat steps
above until properly adjusted.
13