Replacing The Nanocloud Rotary Humidification Wick; Replacing The Anti-Bacteria Cartridge - Philips HU5930 User Manual

2
Remove all packaging material of the new
NanoProtect filter (fig. e).
3
Place the new NanoProtect filter into the
appliance (fig. f).
4
Touch and hold the reset button
3 seconds to reset the NanoProtect filter
lifetime counter (fig. ƒ).
Replacing the NanoCloud
rotary humidification wick
Filter alert light status
Filter replacement
light starts flashing
(fig. †)
1
Take the wick wheel off the wick support
(fig. ~).
2
Unfasten the locks on the edge of the
wheel (fig. ˆ).
3
Grip the snap-fit components on the other
side of the plate to release the wick from
the wheel (fig. ‰).
4
Take the used NanoCloud rotary
humidification wick out (fig. Š) .
5
Remove all packaging material of the new
NanoCloud rotary humidification wick
(fig. ‹).
6
Place the new NanoCloud rotary
humidification wick in the wick wheel, and
then fasten the locks on the wick wheel
(fig. Œ).
7
Place the wick wheel on the wick support
(fig. k).
Note
•
When placing the wick wheel on the wick
support, make sure that the projections on
the wick wheel falls into the corresponding
grooves.
for
Follow this
Replace the
NanoCloud rotary
humidification wick
8
Place the water tray and water tank back
into the appliance.
9
Touch and hold the reset button
for 3 seconds to reset the NanoCloud
rotary humidification wick lifetime counter
(fig. ƒ).
Replacing the anti-bacteria
cartridge (HU5931 only)
Replace the anti-bacteria cartridge at least once
a year to prevent bacteria from growing in the
water tray.
1
Pull and remove the old anti-bacteria
cartridge from the water tray (fig. ).
2
Remove all packaging materials of the new
anti-bacteria cartridge (fig. Ž).
3
Place the new anti-bacteria cartridge into
the groove in the water tray (fig. ).
4
Place the water tracy and water tank back
into the appliance.
EN 11