Gree GWHD(48S)NM3CO Service Manual page 94

Super Free Match
Service Manual
4.5.6 Installation and Servicing Space
4.5.7 Installation of the Indoor Unit
1) Preparation
Open the front panel, remove the 4
screws and dismount the front grille
while pulling it forward.
Follow the arrows to disengage the
clasps on the front case to remove
it.
Follow the procedure below when
removing the slit portions.
2) For Moldings
Remove the pillars. (Remove the slit
portions on the bottom frame using
nippers.)
3) For Side Piping
Remove the pillars.
① Remove the 7screws.
② Remove the upper casing (2 tabs).
③ Remove the left and right casings (2
tabs on each side ).
④ Remove the slit portions on the
bottom frame and casings using nippers .
⑤ Return by following the steps in
reverse order(3>2>1).
INSTALLATION 90